February 2026
Time to make: 3 hours
Finishing: 3 hour
Original design: Bill Macfarlane
3D file: Maya Deat* Whistle (Easy Print, Very Loud) by Tacblades
Note: the name has been changed with google in mind (If you know you know)
It's dark and cold ... there an eerie sound in the distant. Is it a scream? Is it a wail of a wild animal? No it's a Mayan scream whistle. I got to admit I never heard of one before I saw one on an episode of Tracker and yes I've never seen Ghostbuster Afterlife which also mentions it.
Note: the name has been changed with google in mind (If you know you know)
It's dark and cold ... there an eerie sound in the distant. Is it a scream? Is it a wail of a wild animal? No it's a Mayan scream whistle. I got to admit I never heard of one before I saw one on an episode of Tracker and yes I've never seen Ghostbuster Afterlife which also mentions it.
I first printed this on a resin printer which required a lot of supports to print. That was a big mistake because I couldn't effectively remove the supports from inside the chambers. Once I cured the print, it became a paperweight as I could not blow into it. To the FDM printer next and within a few hours I had a working whistle. Next I gave it a black wash, with multi surface hobby paint, to bring out the detail. I added some loops to the back to finish off this slide.
No comments:
Post a Comment